mControl Driver: UPB (Beta)

[Ted Singh]

We'd like to thank Tom Boyce (forum username: tpboyce) for his development effort in creating a driver for the highly-regarded UPB protocol.



View the YouTube video here: http://www.youtube.com/watch?v=GZWzP3xdtZo

The driver is attached here: http://www.embeddedautomation.com/UP...%20080703).zip. To use, please read the setup instructions within the zip file.

The UPB beta driver for mControl works fully until August 31, 2008, after which only one UPB device will be controllable. You must have mControl v2.1 installed.

The final version of this driver should be available later this summer. For more information, please email sales@embeddedautomation.com or PM forum user tpboyce.