Updated: ISY-99 Driver for ISY Firmware V.2.7.x.x

[Ted Singh]

We have updated our Universal Devices ISY-99 driver to allow it to work with upgraded ISY-99 firmwware V.2.7.x.x versions: http://www.embeddedautomation.com/dr...-%20100831.zip



We have tested this with the following configuration:
- mControl v2.1.3818 RC5 B4
- Universal Devices ISY-99 firmware version: Insteon_UD99 V.2.7.1.5

Let us know your results.

[ezzye]

This is great. I'll check when I get off work later.

[ezzye]

Ok, everything seems to be working Ted. I havent tried any macros, just basic linking and turning on lights and such. Thanks, appreciate it. Now, if you can get that nutech driver up and running for my security, I'll be all set until v3.

Thanks again

[dgruehn]

Was able to connect with ISY and see all my devices. VERY much appreciated. I'll be completing a full setup tonight and try running macros and other more complete testing.

And note I'm running ISY firmware 2.8.2 beta...

[dgruehn]

The driver is working great! Awesome job. Been running macros, cameras, and 100+ insteon devices.

[satwar]

Could someone kindly list the steps taken to see the insteon devices configured in the ISY ? I don't get any devices listed after I select ISY Controller..

Thank you in advance

[reakhavok]

Hello,

Im using ISY 2.8.10 and Mcontrol 2.1.3818.3. The log file for mcontrol shows the below. I can't get any of my ISY devices to show up in mcontrol.. does anyone know what I can do to get this resolved?

ISYCTRL: unhandled error in "InternalStartup()" method.
System.MissingMethodException: Method not found: 'Void EmbeddedAutomation.UPnPLib.UPnPController.add_UPnP SearchCompleted(System.EventHandler)'.
at EmbeddedAutomation.mServer.Adapters.ISYFinder.Find IsyUpnpLDevice()
at EmbeddedAutomation.mServer.Adapters.ISYManager.Loc ateAndInitISY(Boolean logMessage)
at EmbeddedAutomation.mServer.Adapters.ISYManager.Int ernalStartup()
at EmbeddedAutomation.mServer.Api.AbstractAdapterDriv er.InternalInit(Object state)