Ted Singh
04-26-2008, 01:32 AM
If you have information on your IP camera, it is likely that it can be supported within mControl.
The following document outlines that parameters that you will need to set for any new camera: http://www.embeddedautomation.com/Camera%20Parameters%20(v1.00%20-%20080425).pdf
Of course, you can always start by reviewing the existing XML definitions of supported cameras within the mServer.exe.xml file.
The following document outlines that parameters that you will need to set for any new camera: http://www.embeddedautomation.com/Camera%20Parameters%20(v1.00%20-%20080425).pdf
Of course, you can always start by reviewing the existing XML definitions of supported cameras within the mServer.exe.xml file.