macro start on external x10

[da-duke]

Is it possible to start a macro with an external x10 command. For example from an x10 remote contol.

[Ted Singh]

da-duke,

Absolutely. Create a X10 device representing the signal that you'd like to use from your X10 remote control. Use this device within your mControl macro condition (e.g., Device Change condition).

Ted

[magnush]

Hi,

I'm wondering if I can do the same with a zwave device?

I currently use my 2 button zwave controller (Tricklestar) for sending ALL ON and ALL OFF, but it would be much more practical to be able to activate a mControl macro.

Any ideas welcome :-)

Best regards,
Magnus