gjniewenhuijse
10-05-2008, 03:49 PM
I use the latest version of mcontrol with a x10 cm11 usb interface.
Switching the lamp gives a delay of 10 secondes after turning the lamp on or off. The lamp goes on, but before i can entering a new command i must wait 10 secondes. Then IE get responding to the off commando.
It look likes IE refreshed the complete page after changing the state of a device. Is this normal behaviour and how can i change tis, so i can quick change between on and off or quick change the status of 4 devices and not to wait 10 seconds between every device change.
Switching the lamp gives a delay of 10 secondes after turning the lamp on or off. The lamp goes on, but before i can entering a new command i must wait 10 secondes. Then IE get responding to the off commando.
It look likes IE refreshed the complete page after changing the state of a device. Is this normal behaviour and how can i change tis, so i can quick change between on and off or quick change the status of 4 devices and not to wait 10 seconds between every device change.